Site Assessment and Load Analysis
Evaluate cooling and heating load demands
Assess available chilled water and hot water systems
Identify heat recovery potential and integration points
System Design and Equipment Selection
Recommend suitable heat pump capacity and configuration
Select model based on COP, flow rates, temperature lift, and control compatibility
Coordinate integration with chilled water plant or domestic hot water system
Equipment Supply and Delivery
Provide high-efficiency water-to-water heat pumps with smart controllers
Supply associated accessories: flow switches, valves, sensors, expansion tanks, etc.
Mechanical Installation
Install heat pump on proper foundation with vibration isolators
Connect chilled water and hot water piping with insulated, properly supported piping
Install necessary bypass valves, strainers, and Y-filters for flow control and protection
Electrical and Control Works
Complete wiring for main power, pump starters, sensors, and BMS interface
Integrate with existing building automation or standalone control panels
Install temperature sensors and flow meters for monitoring and protection
System Commissioning
Perform system start-up and testing
Verify temperature setpoints, flow rates, and pressure levels
Test heat recovery performance and safety controls
Performance Tuning and Optimization
Fine-tune operation modes for maximum energy efficiency
Configure operation schedules and load sharing with existing HVAC systems
Testing & Handover
Conduct reliability and functionality tests under live conditions
Provide as-built drawings, O&M manual, warranty documentation
Deliver client training on operation and routine maintenance
Hotels & Resorts (hot water + cooling)
Hospitals & Clinics (constant hot water demand)
Factories & Laundries
Energy-efficient green buildings
Facilities with simultaneous heating and cooling loads
Malaysia
