MULTIFIX MF-EX2 – 400ML Cartridge
Type: High-strength, two-component epoxy adhesive for anchoring
Size: 400 mL coaxial cartridge
System: Includes static mixing nozzle for immediate use
Color: Gray after mixing
Storage: Store between 5°C and 25°C in a dry place
Shelf Life: 12 months (unopened, under proper storage conditions)
Anchoring threaded rods and reinforcing bars (rebar) into concrete
Heavy-duty structural anchoring in solid concrete (cracked/uncracked)
Suitable for dry, damp, or water-filled holes
Ideal for overhead, horizontal, and vertical installations
Mix Ratio: 3:1 (Resin:Hardener by volume)
Mixed Density: Approx. 1.68 kg/L
Open Time (Workability):
~20–30 min at 20–25°C (dry)
Shorter at higher temperatures
Curing Time:
Functional cure: ~60 minutes at 25°C (dry concrete)
Full cure: Up to 24 hours depending on conditions
Temperature Range for Use: +5°C to +40°C
Cleaning Method: Use blow–brush–blow cleaning cycle before injection
Anchor Sizes:
Threaded Rods: M8 to M32
Rebar: Ø12 to Ø40 mm
Load Resistance: High pull-out and shear strength values
Gap Filling: Up to 0.8 mm
Durability: Designed for ≥50 years service life
Fire Resistance: Certified for up to 4 hours (tested conditions)
ETA certified for threaded rod anchoring in concrete
ETA certified for post-installed rebar connections
Fire-tested according to international standards
Approved for use in structural applications
Drill the correct hole diameter and depth.
Clean the hole thoroughly: blow, brush, blow again.
Insert the mixing nozzle onto the cartridge.
Dispense a small amount of epoxy outside the hole (until color is uniform).
Inject epoxy from the bottom up, filling approx. 2/3 of the hole.
Insert the rod or bar with a twisting motion.
Allow to cure fully before applying load.
No shrinkage after curing
Excellent resistance to chemicals, moisture, and vibration
Easy installation – no special tools required
Works in both overhead and water-affected applications
