74 series Digital Integrated Circuits
HD74LS47P
HD74LS47P

 

HD74LS47P

Utsource Holding Company Limited flag
Category: 74 series Digital Integrated Circuits Available (Qty:9999999)
For more information, visit our official website at utsource.us
Visit Official Site Contact Us
Description

BUY HD74LS47P https://www.utsource.net/itm/p/1706850.html
Decoder/Driver

Parameter Symbol Conditions Min Typ Max Unit
Operating Supply Voltage VCC Operating 4.75 5.0 5.25 V
Input Low Level Voltage VIL IL = 1.6 mA 0.0 - 0.8 V
Input High Level Voltage VIH IH = 20 μA 2.0 - 5.25 V
Output Low Level Voltage VOL IOL = 16 mA 0.0 - 0.5 V
Output High Level Voltage VOH IOH = -0.4 mA 2.7 - 5.25 V
Propagation Delay Time tpd VCC = 5V, TA = 25°C 30 - 60 ns
Power Dissipation PD Continuous - - 100 mW
Operating Temperature Range TA Storage -55 - 125 °C

Instructions for Using HD74LS47P

  1. Power Supply:

    • Connect the VCC pin to a 5V power supply.
    • Ground the GND pin.

  2. Input Connections:

    • Connect the BCD (Binary-Coded Decimal) inputs A, B, C, and D to your digital signal source.
    • Ensure that the input voltages meet the specified levels (VIL and VIH).

  3. Output Connections:

    • The outputs a, b, c, d, e, f, g drive the segments of a 7-segment display.
    • Connect these outputs to the corresponding segments of the display.

  4. Latch Enable (LE):

    • Use the LE pin to control when the BCD input is latched into the decoder.
    • Set LE high to enable latching and low to disable it.

  5. Ripple Blank Input (RBI):

    • Use the RBI pin to blank leading zeros in multiple-digit displays.
    • Set RBI high to enable blanking and low to disable it.

  6. Ripple Blank Output (RBO):

    • The RBO pin can be used to cascade multiple HD74LS47P decoders for multi-digit displays.
    • Connect RBO to the RBI of the next decoder in the chain.

  7. Test Input (LT):

    • Use the LT pin to test the decoder.
    • Set LT low to put the decoder in test mode, which will light all segments of the display.

  8. Operating Conditions:

    • Ensure the operating temperature is within the specified range (-55°C to 125°C).
    • Do not exceed the maximum power dissipation of 100 mW.

  9. Handling:

    • Handle the IC with care to avoid static damage.
    • Store the IC in a dry place to prevent moisture damage.

  10. Schematic Example:

    • Refer to the datasheet for a typical application circuit showing how to connect the HD74LS47P to a 7-segment display and other components.
(For reference only)

More detail about Utsource Holding Company Limited
Utsource Holding Company Limited
Utsource Holding Company Limited Electronic Component Wholesaler, IC Chip Distributor, IGBT Module Supplier in California, USA | Utsource Holding Company Limited
Contact Us flag