LM358N DIP8
LM358N DIP8

 

LM358N DIP8

Utsource Holding Company Limited flag
Category: Available (Qty:9999999)
For more information, visit our official website at utsource.us
Visit Official Site Contact Us
Description

BUY LM358N DIP8 https://www.utsource.net/itm/p/11266285.html

Parameter Symbol Conditions Min Typical Max Unit
Supply Voltage VCC - 3 - 32 V
Input Offset Voltage VIO - - 2 7 mV
Input Bias Current IB - - 45 500 nA
Input Offset Current IOS - - 10 200 nA
Differential Input Voltage VID - ±30 - ±30 V
Common-Mode Input Voltage VICM - 0 - VCC - 1.5 V
Output Short-Circuit Current ISC - - 20 40 mA
Slew Rate SR - - 0.5 1.0 V/μs
Gain Bandwidth Product GBP - - 1.1 1.5 MHz
Operating Temperature Range TA Commercial (N) 0 - 70 °C
TA Industrial (I) -40 - 85 °C

Instructions for Using LM358N DIP8:

  1. Power Supply:

    • Connect the positive supply voltage (VCC) to pin 8.
    • Connect the negative supply voltage (GND) to pin 4.
    • Ensure the supply voltage is within the range of 3V to 32V.

  2. Input Connections:

    • Connect the non-inverting input (pin 3) and inverting input (pin 2) for the first operational amplifier.
    • Connect the non-inverting input (pin 6) and inverting input (pin 5) for the second operational amplifier.
    • Ensure the common-mode input voltage does not exceed VCC - 1.5V.

  3. Output Connections:

    • The output of the first operational amplifier is on pin 1.
    • The output of the second operational amplifier is on pin 7.
    • The output can drive up to 20mA short-circuit current.

  4. Biasing and Feedback:

    • Use appropriate biasing and feedback networks to set the gain and stability of the amplifiers.
    • For inverting configurations, connect the feedback resistor between the output and inverting input.
    • For non-inverting configurations, connect the feedback resistor between the output and the non-inverting input.

  5. Temperature Considerations:

    • Operate the device within the specified temperature range to ensure reliable performance.
    • For commercial applications, use the N version (0°C to 70°C).
    • For industrial applications, use the I version (-40°C to 85°C).

  6. Handling and Storage:

    • Handle the IC with care to avoid static damage.
    • Store in a dry, cool place away from direct sunlight and moisture.

  7. Soldering:

    • Use a soldering iron with a temperature no higher than 300°C.
    • Avoid excessive heat and prolonged heating during soldering to prevent damage to the IC.

  8. Testing:

    • After assembly, test the circuit to ensure proper operation.
    • Verify the supply voltages and input signals are correct before applying power.

By following these instructions, you can effectively use the LM358N DIP8 operational amplifier in your circuits.

(For reference only)

More detail about Utsource Holding Company Limited
Utsource Holding Company Limited
Utsource Holding Company Limited Electronic Component Wholesaler, IC Chip Distributor, IGBT Module Supplier in California, USA | Utsource Holding Company Limited
Contact Us flag