LM324N LM324 DIP-14 : Top Choice in United States (USA) Utsource Holding Company Limited

Description

Parameter	Min	Typ	Max	Unit
Supply Voltage (Vcc)	2.0		36	V
Supply Current (Icc)		0.8		mA
Input Offset Voltage (Vos)	2	5	7	mV
Input Bias Current (Ib)	20	50	100	nA
Input Impedance (Zi)		10^12		Ω
Output Short-Circuit Current		20	40	mA
Slew Rate (SR)		0.5		V/μs
Common-Mode Rejection Ratio		85		dB
Power Dissipation (PD)		720		mW
Operating Temperature Range	-40		125	°C

Power Supply:
- Connect the positive supply voltage (Vcc) to pin 4 and the negative supply voltage (GND) to pin 11.
- For single-supply operation, connect Vcc to the positive supply and GND to ground.
Input Connections:
- Connect the non-inverting input (pin 3, 5, 7, 9) and inverting input (pin 2, 6, 8, 10) to your signal sources.
- Ensure that the input voltages do not exceed the supply voltage range.
Output Connections:
- The output pins (pins 1, 7, 13, 14) can be connected to the load or further stages of the circuit.
- The output can swing from 0V to approximately 1.5V below Vcc.
Biasing:
- Use external resistors to bias the inputs as needed for your specific application.
- For differential amplifiers, ensure the inputs are properly biased to avoid saturation.
Decoupling Capacitors:
- Place a 0.1μF ceramic capacitor between Vcc and GND close to the IC to filter out noise and stabilize the power supply.
Temperature Considerations:
- Operate the IC within the specified temperature range to ensure reliable performance.
- Avoid exposing the IC to extreme temperatures to prevent damage.
Handling:
- Handle the IC with care to avoid static discharge, which can damage the sensitive components.
- Use proper ESD protection when handling the IC.
Testing:
- Before integrating the LM324N into a larger circuit, test it with a simple configuration (e.g., a basic amplifier) to ensure it is functioning correctly.

By following these instructions, you can effectively use the LM324N in your electronic projects.

(For reference only)