Description
BUY TLP598A https://www.utsource.net/itm/p/913133.html
Solid State Relay, TRANSISTOR OUTPUT SOLID STATE RELAY, 2500 V ISOLATION-MAX, PLASTIC, 11-9A1, DIP-6
| Parameter |
Symbol |
Min |
Typ |
Max |
Unit |
Conditions/Notes |
| Forward Voltage (LED) |
VF |
- |
1.2 |
1.6 |
V |
IF = 20mA |
| Reverse Voltage (LED) |
VR |
- |
- |
5 |
V |
|
| Forward Current (LED) |
IF |
- |
- |
50 |
mA |
Continuous |
| Peak Forward Current (LED) |
IF(peak) |
- |
- |
150 |
mA |
Pulse width ≤ 1ms, duty cycle ≤ 2% |
| Storage Temperature |
TSTG |
-40 |
- |
110 |
°C |
|
| Operating Temperature |
TA |
-40 |
- |
105 |
°C |
|
| Isolation Voltage |
VIORM |
- |
- |
3750 |
Vrms |
1 minute, 50/60Hz |
| Output Leakage Current |
IOL |
- |
0.1 |
1 |
μA |
VO = 0V to VCE(sat), TA = 25°C |
| Output Turn-On Time |
ton |
- |
1 |
3 |
μs |
IF = 20mA, RL = 500Ω, VO = 5V |
| Output Turn-Off Time |
toff |
- |
1 |
3 |
μs |
IF = 20mA, RL = 500Ω, VO = 5V |
Instructions for Use:
Power Supply:
- Ensure the power supply voltage is within the specified range for both the input and output sides.
- Use appropriate decoupling capacitors near the power pins to reduce noise.
Input Side (LED):
- Connect the LED side to a suitable current source or limit the current using a resistor.
- Do not exceed the maximum forward current (IF) or peak forward current (IF(peak)).
- Ensure the reverse voltage (VR) does not exceed the maximum rating.
Output Side:
- Connect the output to the load through a suitable pull-up resistor.
- Ensure the output leakage current (IOL) is within acceptable limits for your application.
- Check the output turn-on and turn-off times (ton and toff) to ensure they meet your timing requirements.
Isolation:
- Verify that the isolation voltage (VIORM) is sufficient for your application to ensure safety and reliability.
- Maintain proper clearance and creepage distances between the input and output sides.
Temperature:
- Operate the device within the specified temperature ranges to avoid damage and ensure reliable performance.
- Consider thermal management solutions if operating at high temperatures.
Storage:
- Store the device in a dry, cool environment to prevent moisture damage and degradation.
Handling:
- Handle the device with care to avoid static discharge, which can damage the internal components.
- Follow ESD (Electrostatic Discharge) precautions during handling and assembly.
(For reference only)
More detail about Utsource Holding Company Limited
