HCPL-2200-000E: Top Choice in United States (USA) Utsource Holding Company Limited

Description

BUY HCPL-2200-000E https://www.utsource.net/itm/p/4490842.html
Low Input Current Logic Gate Optocouplers

Parameter	Symbol	Min	Typical	Max	Unit
Input Current (Forward)	IF	-	15	30	mA
Input Voltage (Forward)	VIF	1.1	1.3	1.5	V
Input Capacitance	CIN	-	10	-	pF
Output Current (High Level)	IOH	-	1.6	4.0	mA
Output Current (Low Level)	IOL	8.0	16	24	mA
Output Voltage (High Level)	VOH	2.4	3.5	5.5	V
Output Voltage (Low Level)	VOL	-	0.1	0.4	V
Propagation Delay Time (Input to Output)	tpd	30	50	70	ns
Power Dissipation (Total)	PTOT	-	125	-	mW
Operating Temperature Range	Toper	-40	-	85	°C
Storage Temperature Range	Tstg	-65	-	150	°C

Power Supply:
- Ensure the power supply voltage is within the specified range (VCC: 4.5V to 5.5V).
- Connect the ground (GND) pin to a stable ground reference.
Input Signal:
- Apply a forward current (IF) between 15mA and 30mA to the input pin.
- The input voltage (VIF) should be between 1.1V and 1.5V for reliable operation.
Output Signal:
- For high-level output, ensure the output voltage (VOH) is at least 2.4V.
- For low-level output, ensure the output voltage (VOL) is no more than 0.4V.
- The output current (IOH) when high should not exceed 4.0mA, and the output current (IOL) when low should be at least 8.0mA.
Propagation Delay:
- The propagation delay time (tpd) from input to output is typically 50ns, with a minimum of 30ns and a maximum of 70ns.
Thermal Management:
- Operate the device within the temperature range of -40°C to 85°C.
- Store the device within the temperature range of -65°C to 150°C.
Power Dissipation:
- Ensure the total power dissipation (PTOT) does not exceed 125mW to avoid overheating.
Capacitance:
- The input capacitance (CIN) is typically 10pF, which can affect signal integrity at high frequencies.
Handling:
- Handle the device with care to avoid static damage.
- Follow proper soldering techniques to ensure reliable connections.
Testing:
- Test the device under controlled conditions to verify its performance parameters before integrating it into your design.

(For reference only)