CD4046B

BUY CD4046B https://www.utsource.net/itm/p/11547541.html

Instructions for Using the CD4046B

1. Supply Voltage:

   • Ensure the supply voltage (V_CC) is within the range of 3.0V to 15.0V.
   • The typical operating voltage is 5.0V.

2. Supply Current:

   • The quiescent current (I_CC) can vary from 2.5mA to 5.0mA at 5V supply voltage.

3. Phase Detector:

   • Connect the input signal to the phase detector input (pin 14).
   • The output voltage (V_out) will be proportional to the phase difference between the input signal and the VCO output.
   • The output current (I_out) can drive up to 20mA.

4. VCO (Voltage-Controlled Oscillator):

   • The VCO frequency (f_VCO) can be adjusted by varying the control voltage (V_ctl) from 0V to V_CC.
   • The VCO frequency range is typically 10kHz to 1MHz at 5V supply voltage.
   • Use external components (capacitors and resistors) to set the center frequency and range of the VCO.

5. Propagation Delay:

   • The propagation delay (t_d) is the time it takes for the phase detector to respond to changes in the input signal.
   • Typical values range from 10ns to 50ns at 5V supply voltage.

6. Power Dissipation:

   • Ensure that the power dissipation (P_D) does not exceed 200mW to avoid overheating the device.

7. Pin Configuration:

   • Refer to the datasheet for the specific pin configuration and connections.
   • Ensure all unused inputs are tied to V_CC or ground to prevent floating inputs.

8. Handling Precautions:

   • Handle the CD4046B with care to avoid static damage.
   • Use proper ESD protection when handling the device.

9. Testing:

   • Before integrating the CD4046B into a circuit, test it on a breadboard to ensure it functions correctly.
   • Verify the VCO frequency and phase detector output using an oscilloscope.

10. Applications:

    • The CD4046B is commonly used in PLL (Phase-Locked Loop) circuits, frequency synthesizers, and clock recovery applications.