Elec-component
AD8226ARMZ-RL
AD8226ARMZ-RL

 

AD8226ARMZ-RL

Utsource Holding Company Limited flag
Category: Elec-component Available (Qty:9999999)
For more information, visit our official website at utsource.us
Visit Official Site Contact Us
Description

BUY AD8226ARMZ-RL https://www.utsource.net/itm/p/12612478.html

Parameter Description Min Typ Max Unit
Supply Voltage (V+) Operating supply voltage range 2.7 - 36 V
Quiescent Current Supply current at V+ = 5V, no load - 1.4 - mA
Input Voltage Range Common-mode input voltage range -0.1 - V+ + 0.1 V
Differential Input Voltage Maximum differential input voltage ±15 - - V
Output Voltage Swing Output voltage swing (V+ = 5V) 0.1 - 4.9 V
Bandwidth (GBW) Gain-bandwidth product (V+ = 5V) - 1.3 - MHz
Slew Rate Rate of change of output voltage with respect to time - 0.5 - V/μs
Input Bias Current Typical input bias current - 0.5 - nA
Input Offset Voltage Initial offset voltage - 250 - μV
CMRR Common-mode rejection ratio 86 - 120 dB
PSRR Power supply rejection ratio 86 - 120 dB
Temperature Range Operating temperature range -40 - 125 °C

Instructions for Using AD8226ARMZ-RL

  1. Power Supply:

    • Ensure the supply voltage (V+) is within the specified range of 2.7V to 36V.
    • Connect the positive supply to the V+ pin and the negative supply (ground) to the GND pin.

  2. Input Connections:

    • Connect the differential input signals to the IN+ and IN- pins.
    • Ensure the common-mode input voltage is within the range of -0.1V to V+ + 0.1V.
    • The maximum differential input voltage should not exceed ±15V.

  3. Output Configuration:

    • The output voltage swing is typically from 0.1V to 4.9V when V+ is 5V.
    • Connect the output to the desired load or next stage of the circuit.

  4. Biasing and Offset:

    • The input bias current is very low (0.5nA typical), so external biasing components may not be necessary.
    • The initial input offset voltage is 250μV typical, which can be minimized using external trimming circuits if required.

  5. Performance Considerations:

    • The gain-bandwidth product (GBW) is 1.3MHz, which affects the frequency response of the amplifier.
    • The slew rate is 0.5V/μs, which limits the maximum rate of change of the output voltage.

  6. Environmental Conditions:

    • The device operates over a temperature range of -40°C to 125°C.
    • Ensure the operating environment does not exceed these limits to avoid damage or reduced performance.

  7. Protection:

    • The device has built-in protection against overvoltage and reverse polarity on the inputs and outputs.
    • However, it is advisable to include external protection circuits for harsh environments.

  8. Mounting and Handling:

    • Handle the device with care to avoid static discharge and mechanical damage.
    • Follow recommended soldering and mounting procedures to ensure reliable operation.
(For reference only)

More detail about Utsource Holding Company Limited
Utsource Holding Company Limited
Utsource Holding Company Limited Electronic Component Wholesaler, IC Chip Distributor, IGBT Module Supplier in California, USA | Utsource Holding Company Limited
Contact Us flag