74LS247N

BUY 74LS247N https://www.utsource.net/itm/p/239581.html

Instructions for Using 74LS247N:

1. Power Supply:

   • Connect Vcc to +5V and GND to ground.
   • Ensure the supply voltage is within the specified range (4.75V to 5.25V).

2. Input Connections:

   • Connect the BCD inputs (A, B, C, D) to the appropriate logic levels (0V for low, 5V for high).
   • Unused inputs should be tied to a known state (either Vcc or GND) to avoid floating conditions.

3. Output Connections:

   • The 7-segment outputs (a, b, c, d, e, f, g) can drive LEDs or other displays directly if the current requirements are within the output current limits.
   • Use current-limiting resistors with LEDs to prevent damage.

4. Operation:

   • The 74LS247N converts a 4-bit binary-coded decimal (BCD) input into a 7-segment code suitable for driving a common cathode 7-segment display.
   • Ensure that the BCD input is within the valid range (0000 to 1001) to avoid undefined behavior.

5. Propagation Delay:

   • The propagation delay time (tpd) is the time it takes for a change in the input to affect the output. It typically ranges from 22ns to 34ns.

6. Power Dissipation:

   • The maximum power dissipation is 100mW. Ensure proper heat dissipation if operating near this limit.

7. Storage and Handling:

   • Store the IC in a static-protective bag to prevent damage from electrostatic discharge (ESD).
   • Handle the IC by the edges and avoid touching the pins.

8. Testing:

   • Before integrating the 74LS247N into a circuit, test it using a simple setup to verify functionality.
   • Apply known BCD inputs and observe the corresponding 7-segment outputs.

By following these instructions, you can ensure reliable operation of the 74LS247N in your digital circuits.