74 series Digital Integrated Circuits
SN74HC377N
SN74HC377N

 

SN74HC377N

Utsource Holding Company Limited flag
Category: 74 series Digital Integrated Circuits Available (Qty:9999999)
For more information, visit our official website at utsource.us
Visit Official Site Contact Us
Description

BUY SN74HC377N https://www.utsource.net/itm/p/1533344.html
Octal Bus Transceiver; Package: TSSOP 20 LEAD; No of Pins: 20; Container: Tape and Reel; Qty per Container: 2500

Parameter Symbol Min Typical Max Unit
Supply Voltage VCC 2.0 - 6.0 V
Input Low Voltage VIL -0.5 - 1.5 V
Input High Voltage VIH 3.5 - VCC + 0.5 V
Output Low Voltage VOL -0.5 - 0.4 V
Output High Voltage VOH 2.4 - VCC + 0.5 V
Input Leakage Current IIL - -1 - μA
Output Leakage Current IOL - -10 - μA
Propagation Delay Time tpd - 12 30 ns
Power Dissipation per Package PD - - 340 mW
Operating Temperature Range TA -40 - 85 °C
Storage Temperature Range TSTG -65 - 150 °C

Instructions for SN74HC377N

  1. Power Supply:

    • Ensure the supply voltage (VCC) is within the range of 2.0V to 6.0V.
    • Connect the ground (GND) pin to a stable reference ground.

  2. Input Signals:

    • Apply input signals such that the low level (VIL) is below 1.5V and the high level (VIH) is above 3.5V.
    • Avoid exceeding the maximum input voltage (VCC + 0.5V).

  3. Output Signals:

    • The output low voltage (VOL) should be below 0.4V.
    • The output high voltage (VOH) should be above 2.4V but not exceed VCC + 0.5V.

  4. Propagation Delay:

    • The typical propagation delay time (tpd) is 12ns, with a maximum of 30ns.

  5. Temperature Considerations:

    • Operate the device within the temperature range of -40°C to 85°C.
    • Store the device in an environment between -65°C and 150°C.

  6. Power Dissipation:

    • Ensure the total power dissipation (PD) does not exceed 340mW to avoid overheating.

  7. Handling:

    • Handle the device with care to avoid static damage.
    • Use proper ESD protection when handling the device.

  8. Pin Configuration:

    • Refer to the datasheet for the specific pin configuration and ensure correct connections.

  9. Testing:

    • Before finalizing the design, test the device under various conditions to ensure reliable operation.

  10. Compliance:

    • Ensure compliance with relevant safety and regulatory standards for your application.
(For reference only)

More detail about Utsource Holding Company Limited
Utsource Holding Company Limited
Utsource Holding Company Limited Electronic Component Wholesaler, IC Chip Distributor, IGBT Module Supplier in California, USA | Utsource Holding Company Limited
Contact Us flag