MB10S

BUY MB10S https://www.utsource.net/itm/p/5447088.html
0.5Amp Single Phase Glass Passivated Bridge Rectifier 50 to 1000 Volts

Instructions for Use

1. Input Connection:

   • Connect the input voltage (VIN) to the positive terminal of the power supply.
   • Ensure the input voltage is within the operating range of 4.5V to 28V.

2. Output Configuration:

   • Adjust the output voltage (VOUT) using an external resistor divider network connected to the FB (feedback) pin.
   • The output voltage can be set from 0.9V to VIN - 0.6V.

3. Output Load:

   • The MB10S can provide up to 3A of continuous output current.
   • Ensure the load does not exceed this limit to avoid overcurrent protection triggering.

4. Thermal Management:

   • The device has built-in thermal shutdown to protect against overheating.
   • For high current applications, ensure adequate heat dissipation by mounting the device on a heatsink or PCB with good thermal conductivity.

5. Shutdown Mode:

   • To put the device into shutdown mode, pull the EN (enable) pin low.
   • In shutdown mode, the quiescent current drops to less than 1μA.

6. PCB Layout:

   • Place the input and output capacitors as close as possible to the device to minimize parasitic inductance.
   • Use wide traces for the input and output paths to reduce resistance and improve performance.

7. Protection:

   • The MB10S includes overcurrent protection and thermal shutdown to safeguard against short circuits and excessive temperature.
   • Ensure the input voltage and load are within the specified limits to avoid triggering these protections.

8. Storage and Handling:

   • Store the device in a dry, cool place away from direct sunlight.
   • Handle the device with care to avoid static damage; use ESD protection where necessary.