Diodes
3SK151-GR
3SK151-GR

 

3SK151-GR

Utsource Holding Company Limited flag
Category: Diodes Available (Qty:9999999)
For more information, visit our official website at utsource.us
Visit Official Site Contact Us
Description

BUY 3SK151-GR https://www.utsource.net/itm/p/11291336.html
3SK151-GR MOSFET N-Channel 15V 30mA SOT-143/SOT-24/SC-61 marking UH high converting gain/low noise gain control amplifier coefficient

Parameter Symbol Value Unit
Maximum Collector-Emitter Voltage VCE(max) 800 V
Maximum Emitter-Base Voltage VEB(max) 5 V
Maximum Collector Current (Continuous) IC(max) 400 A
Maximum Collector Current (Pulse) IC(p) 600 A
Maximum Power Dissipation PT(max) 2500 W
Maximum Junction Temperature TJ(max) 150 °C
Storage Temperature Range TSTG -55 to 150 °C
Transition Frequency fT 10 MHz
Saturation Voltage (VCE(sat)) at IC = 100A, IB = 5A VCE(sat) 1.7 V
Storage Time tstg 1.5 μs

Instructions for Use:

  1. Handling Precautions:

    • Handle the 3SK151-GR with care to avoid mechanical damage.
    • Use proper anti-static measures to prevent damage from electrostatic discharge (ESD).

  2. Mounting:

    • Ensure that the mounting surface is clean and flat.
    • Apply thermal compound between the device and the heat sink to improve thermal conductivity.
    • Tighten the mounting screws to the recommended torque to ensure good thermal contact.

  3. Electrical Connections:

    • Connect the collector, emitter, and base terminals correctly to avoid damage.
    • Use appropriate wire gauges to handle the maximum current ratings.

  4. Thermal Management:

    • Ensure adequate cooling to keep the junction temperature below the maximum rating.
    • Monitor the temperature during operation and adjust the cooling as necessary.

  5. Operating Conditions:

    • Do not exceed the maximum voltage, current, or power ratings.
    • Operate within the specified temperature range to ensure reliable performance.

  6. Storage:

    • Store the device in a dry, cool place away from direct sunlight.
    • Keep the device in its original packaging until ready for use to protect against moisture and static.

  7. Testing:

    • Perform initial testing under controlled conditions to verify proper operation.
    • Use a suitable test setup to avoid overloading the device.

  8. Disposal:

    • Dispose of the device according to local environmental regulations.
    • Recycle components where possible to minimize environmental impact.
(For reference only)

More detail about Utsource Holding Company Limited
Utsource Holding Company Limited
Utsource Holding Company Limited Electronic Component Wholesaler, IC Chip Distributor, IGBT Module Supplier in California, USA | Utsource Holding Company Limited
Contact Us flag