Description
BUY SI2309CDS-T1-GE3 https://www.utsource.net/itm/p/11551845.html
| Parameter |
Description |
Value |
| Part Number |
Full Part Number |
SI2309CDS-T1-GE3 |
| Type |
Device Type |
N-Channel MOSFET |
| Package |
Package Type |
TO-252 (DPAK) |
| VDSS |
Drain-to-Source Voltage |
60V |
| RDS(on) |
On-State Resistance at VGS = 10V |
8.5mΩ |
| ID |
Continuous Drain Current |
14A |
| Ptot |
Total Power Dissipation (Ta = 25°C) |
2.2W |
| Qg |
Total Gate Charge |
27nC |
| fmax |
Maximum Operating Frequency |
5MHz |
| VGS(th) |
Gate Threshold Voltage |
1.0V to 2.5V |
| TJ |
Junction Temperature Range |
-55°C to 150°C |
| Storage Temperature Range |
Storage Temperature |
-65°C to 150°C |
Instructions for Use:
Mounting and Handling:
- Ensure that the device is handled with care to avoid damage to the leads or the body.
- Follow proper ESD (Electrostatic Discharge) precautions to prevent damage to the MOSFET.
Soldering:
- Use a soldering iron with a temperature setting between 260°C and 300°C.
- Solder each lead for no more than 5 seconds.
- Allow the device to cool naturally after soldering.
Thermal Management:
- Ensure adequate heat sinking to maintain the junction temperature within the specified range.
- Use thermal paste or a thermal pad to improve heat transfer from the device to the heatsink.
Electrical Connections:
- Connect the drain, source, and gate terminals correctly to avoid damage.
- Ensure that the gate voltage does not exceed the maximum ratings.
- Use decoupling capacitors close to the power supply pins to reduce noise and improve stability.
Operating Conditions:
- Operate the device within the specified voltage and current limits.
- Monitor the temperature of the device during operation to ensure it does not exceed the maximum junction temperature.
Testing:
- Use a multimeter or an oscilloscope to verify the correct operation of the MOSFET.
- Test the device under load conditions to ensure it meets the required performance specifications.
Storage:
- Store the device in a dry, cool place away from direct sunlight.
- Keep the device in its original packaging until ready for use to protect against moisture and static damage.
(For reference only)
More detail about Utsource Holding Company Limited
