In 2026, Fresh Air Riser Pressure Testing is a mandatory commissioning and maintenance requirement for high-rise commercial buildings. Under the EECA 2024 (Energy Efficiency and Conservation Act) and the DOSH ICOP IAQ 2026, a leaky riser is no longer just a "minor issue"—it is a major energy drain that can disqualify a building from its 5-star Energy Intensity Label.
At EKG M&E, we leverage 34 years of mechanical expertise to perform DW/143-compliant pressure tests on vertical fresh air shafts, ensuring that 100% of the air "injected" at the roof reaches the bottom-most floors.
For 2026 federal audits in Malaysia, fresh air risers (typically High or Medium Pressure) must meet the BESA DW/143 Guide to Good Practice:
Classification Audit: We test based on the duct pressure class (Class A, B, or C). Most vertical risers in KL towers are Class C (High Pressure), requiring a maximum allowable leakage rate calculated by:
(where f is the leakage rate in l/s m^2 and p is the static pressure in Pa).
The 10 l/s Guarantee: If the riser leaks, the lower floors will never receive the mandatory 10 l/s per person of fresh air. Pressure testing is the only way to verify that the "Fresh Air Injection" remains consistent across all 40+ floors.
The EECA 2024 treats air leakage as "unaccounted-for energy waste." A riser leaking just 10% of its volume forces the main fan to run significantly harder to maintain pressure.
The Cube Law Penalty: Because fan power follows the Cube Law ($P \propto n^3$), a 10% increase in fan speed to compensate for leaks results in a 33% increase in power consumption.
BEI Impact: This unnecessary power draw spikes your Building Energy Index (BEI), potentially dropping your building from a 4-star to a 2-star rating, which triggers mandatory energy improvement plans under the 2024 Act.
Fresh air risers are subject to high static pressures that can "stress-test" the duct seams over time.
FFT Vibration Audit: We use Fast Fourier Transform (FFT) analysis during the pressure test to identify "Panting" (audible duct expansion). If the riser is not properly reinforced, the pressure pulse can cause harmonic vibration that leads to seam failure and acoustic noise in the elevator lobbies.
Ultrasonic Leak Detection: For active buildings where smoke testing isn't feasible, we use ultrasonic sensors to "hear" the high-frequency hiss of air escaping from pressurized riser joints, allowing for surgical repairs without opening the entire shaft.
We utilize the TSI PANDA (Pressure Analysis and Leakage Detection) system for 2026-grade accuracy:
| Test Stage | Action | 2026 Deliverable |
| Sectional Isolation | Sealing the riser at every floor takeoff. | Verified "Closed Loop" for testing. |
| Pressurization | Ramping the riser to 1.25x operating pressure. | Real-time leakage flow measurement ($l/s$). |
| Smoke Tracking | Injecting non-toxic theatrical smoke. | Visual identification of leak points in the shaft. |
| Digital Logging | Continuous data recording via BMS/BIM. | Audit-ready report for Registered Energy Managers. |
34 Years of Engineering Depth: We understand the complex vertical aerodynamics of Malaysia's tallest towers.
Audit-Ready Certification: We provide the Pressure Test Certificates and Leakage-vs-Energy Analysis required for 2026 federal compliance.
Precision Remediation: If a leak is found, we specialize in Aerosolized Duct Sealing, which seals the riser from the inside without hacking any walls.
Malaysia
