In the dense commercial and industrial sectors of KL and Selangor, where ceiling space is at a premium, the Centrifugal In-Line Exhaust Fan is the preferred choice for high-performance ventilation. Unlike traditional "box" fans, these units are designed to be installed directly into the ductwork, combining the space-saving benefits of an axial fan with the high-pressure capabilities of a centrifugal blower. EKG M&E Sdn Bhd specializes in the selection and installation of these units for long duct runs where standard fans would fail to move air.
The primary advantage of a centrifugal in-line fan is its ability to overcome the resistance (static pressure) of long, winding ductwork, filters, and louvers.
Sirocco and Backward-Curved Impellers:
We utilize "squirrel cage" or backward-curved impellers that pull air into the center and throw it outward. This mechanical action creates the force necessary to push air through 20+ meters of ducting without a significant drop in Cubic Meters per Hour (CMH).
Quiet, High-Static Operation:
Because the motor is typically housed within a lined, galvanized steel casing, these fans are significantly quieter than axial models of the same power. They are ideal for "Noise Sensitive" zones like boardrooms, clinics, and high-end retail outlets.
Inline "Straight-Through" Design:
Despite the internal centrifugal action, the inlet and outlet are aligned. This allows for a clean, professional installation in tight ceiling voids without the need for bulky 90-degree transitions.
As an HVAC and Clean Air Specialist, we deploy centrifugal in-line technology for three main scenarios:
Extracting heavy moisture and cooking odors requires high suction.
Grease Management: We install units with "easy-access" panels, allowing maintenance teams to clean the impeller without dismantling the entire duct system.
Back-Draft Protection: We ensure every installation includes a check-valve to prevent external odors from entering the building when the fan is idle.
In KL's tall office towers, bathroom air often travels through long vertical shafts to reach the roof.
Overcoming Vertical Lift: We calibrate the fan speed to ensure the air actually reaches the exterior, preventing "smell pockets" on the upper floors.
We use these fans to assist Primary Air Handling Units (PAHU) in moving treated air to the furthest corners of a floor plate.
VFD Integration: We utilize Variable Frequency Drives (VFDs) to modulate the fan speed. If a CO2 Sensor detects low occupancy, the VFD slows the fan to save energy; if occupancy rises, it ramps up to maintain the Air Change Rate (ACR).
| Feature | Axial In-Line Fan | Centrifugal In-Line Fan |
| Max Duct Length | Short (Direct Exhaust). | Long (Multi-room / High Rise). |
| Noise Level | Higher (Vibration). | Lower (Acoustically Lined). |
| Static Pressure | Low. | High. |
| Energy Efficiency | High for open areas. | High for ducted resistance. |
Airflow Balancing and Commissioning: We don't just "install and leave." We perform a professional Duct Traverse and Flow Hood test to ensure the fan is hitting its design setpoint.
Building Pressure Management: We ensure your exhaust fan is balanced with the Building Fresh Air Intake. We prevent the "Whistling Door" effect by making sure your exhaust isn't creating excessive negative pressure in the office.
Klang Valley Strategic Support: Based in Kuala Lumpur, we provide on-site diagnostics, bearing replacements, and motor troubleshooting for centrifugal systems across the Klang Valley.
Malaysia
