Bridge the gap between your professional instruments and benchtop testing with the Laboratory Series. This BNC Male to Dual 4mm Banana Plug Cable is the definitive solution for engineers and technicians. It allows for a direct, high-quality connection from an oscilloscope or signal generator to power supplies, breadboards, and multi-meter testing points.
Molded Branch Design: Features a rugged Y-junction that splits the coaxial signal into two flexible leads, providing better maneuverability than rigid adapters.
Clear Polarity Coding: Equipped with a Red lead for the signal (center pin) and a Black lead for the ground (shield) to ensure error-free circuit integration.
High-Flexibility Shielded Wire: Built with low-loss coaxial cable that transitions into flexible PVC-insulated leads, maintaining signal integrity while resisting tangles.
Electronic R&D: Connect your signal generator directly to a breadboard or custom circuit for real-time waveform testing.
Calibration & Measurement: Use in conjunction with high-precision multimeters or frequency counters to monitor device outputs.
Education & Physics Labs: An essential tool for students learning to use oscilloscopes and signal analyzers.
Repair & Maintenance: Perfect for injecting audio or RF signals into legacy equipment where standard probes are difficult to attach.
Stackable Banana Plugs: Most models feature a 4mm female jack on the back of the banana plugs, allowing you to "stack" additional leads for complex monitoring.
Internal Strain Relief: Reinforced at the BNC head and the Y-split to prevent internal wire breakage during frequent use in the field or lab.
Optimized Impedance: Designed to minimize signal reflection in standard low-to-medium frequency testing environments.
Product Type: BNC Male to Dual 4mm Banana Plug (Male)
Connector A: BNC Male (Plug)
Connector B: 2x Banana Plugs (Red/Black)
Included: 1x BNC to Dual Banana Testing Cable
1. Can I stack these on top of each other? Yes! These plugs usually feature a "pass-through" hole or socket on the back, allowing you to plug another set of banana leads into them for parallel testing.
2. Is the cable shielded all the way to the split? The main body of the cable is shielded coaxial. Once it hits the Y-split, the leads become separate wires to allow you to reach different points on your circuit.
3. Will this work with my oscilloscope? Absolutely. This is a standard 1:1 cable. Keep in mind it does not have the 10x attenuation found on standard scope probes, so it is best for direct signal measurement within the scope's voltage limits.
更多 EMX Electronic Trading Sdn Bhd 相关资料
Malaysia
