This 4-pin industrial toggle switch is engineered for high-performance applications that require the simultaneous control of two separate electrical lines. Featuring a Double Pole Single Throw (DPST) configuration, this switch provides a clean ON-OFF maintained action, making it an essential component for power distribution in industrial, marine, and commercial machinery.
High-Capacity Power Rating: Rated at 15A 250VAC, designed to safely manage high-amperage loads across multiple circuits.
DPST 4-Terminal Interface: Equipped with four robust screw terminals, allowing for the concurrent switching of two independent power legs or a complete disconnect of both hot and neutral lines.
Maintained ON-OFF Logic: Features a positive locking mechanical action that stays in your chosen position until manually toggled back.
Industrial-Grade Construction: Built with a heat-resistant bright orange thermoset housing and a reinforced metal mounting frame for maximum mechanical longevity.
Professional Mounting Kit: Includes a high-visibility "ON-OFF" status plate, hex mounting nuts, and a locking washer for a vibration-resistant panel installation.
Power Isolation: Ideal for use as a primary power disconnect where both sides of a circuit must be broken for safety.
Industrial Workshop Equipment: Perfect for controlling heavy-duty vacuum systems, bench grinders, or large lighting arrays.
Marine Control Panels: Frequently utilized in boat electrical systems to manage dual-battery banks or high-draw navigational equipment.
Electrical Rating: 15A 250VAC.
Circuitry: DPST (4 Pins).
Switching Action: Maintained ON - Maintained OFF.
Terminal Type: 4 x Heavy-Duty Industrial Screw Terminals.
Can I use this switch to control two different devices at once?
Yes. Because it is a 4-pin DPST switch, you can wire two separate circuits through it and turn them both on or off with a single flick of the lever.
Does this switch spring back to center?
No. This is a maintained switch, meaning it will stay in the position you move it to until you manually change it.
What mounting hole size is required?
This switch uses a standard industrial 12mm threaded bushing, requiring a 12mm (approx. 1/2") hole for secure panel mounting.
Malaysia
