Nippon Paint 8000 Expresskote Sealer is a high-performance water-based sealer specifically formulated for use on new interior and exterior masonry surfaces. This advanced sealer is engineered to allow for faster painting schedules, as it can be applied onto freshly plastered walls after only 3 days of drying, compared to the standard 28 days required for conventional sealers. It provides excellent alkaline and efflorescence resistance, protecting the topcoat from discoloration and salt formation. Its superior adhesion and breathable film allow moisture to escape from the substrate without damaging the paint film. As a "Green Choice" product, it is low in VOC and low in odor, making it safe for both applicators and the environment.
Paint Type: Water-based (Interior & Exterior)
Finishing: Matt
Binder: Styrene Acrylic Emulsion
Thinning: Maximum 5% with clean water (preferably not diluted for best performance)
Touch Dry: 15 minutes (depending on temperature and humidity)
Hard Dry: 1 hour
Recoating Interval: Minimum 2 hours
Theoretical Coverage: 10 – 12 m² per litre per coat
No. of Coats: 1 coat
Shelf Life: Up to 36 months in a tightly sealed container
Application Method: Apply using a high-quality Brush, Roller, or Conventional Air Spray.
Dilution: Ready for use after thorough stirring. If thinning is required for workability, dilute with no more than 5% clean water.
Cleaning: Clean all painting equipment with clean water immediately after use.
Note: While it can be applied after 3 days of plastering, ensure the surface is visibly dry and free from any standing water or extreme moisture saturation.
Sealer/Primer (1 Coat): 8000 Expresskote Sealer.
Topcoat (2 Coats): Nippon Paint Interior or Exterior Products (e.g., Weatherbond, Vinilex Fresh, or Satin Glo).
Application Window: Suitable for application on plastered walls, concrete, and rendered surfaces that have cured for at least 3 days.
General Cleaning: Surface must be dry, clean, and free from grease, oil, dust, and loose matter.
Defect Removal: Remove all loose or defective paint, powdery residues, and dust by scraping or brushing.
Biological Treatment: Treat areas affected by fungus or algae growth with a suitable fungicidal wash solution.
Repair: Repair cracks and uneven surfaces with suitable masonry fillers and sand until smooth.
Conditioning: For new walls, ensure the surface has dried for at least 3 days. For old walls, ensure the surface is thoroughly cleaned and free from any existing peeling paint.
Malaysia
