67L050: 马来西亚的首选 Utsource Holding Company Limited

详情

BUY 67L050 https://www.utsource.net/itm/p/12610372.html

Parameter	Symbol	Min	Typ	Max	Unit	Description
Supply Voltage	Vcc	2.0	3.3	5.5	V	Operating voltage range
Standby Current	Istandby	-	1.0	-	μA	Current consumption in standby mode
Active Current	Iactive	-	10	-	mA	Current consumption in active mode
Input Voltage Range	Vin	0	-	Vcc	V	Range of input voltages
Output Voltage Range	Vout	0	-	Vcc	V	Range of output voltages
Operating Temperature	Temp	-40	-	85	°C	Temperature range for operation
Storage Temperature	Tstore	-55	-	125	°C	Temperature range for storage
Output Current	Iout	-	50	100	mA	Maximum continuous output current
Power Dissipation	Pdiss	-	-	500	mW	Maximum power dissipation
Response Time	tresp	-	10	-	μs	Time to respond to input changes

Instructions for Using 67L050

Power Supply Connection:
- Connect the supply voltage (Vcc) to the appropriate pin.
- Ensure the supply voltage is within the specified range (2.0V to 5.5V).
Standby Mode:
- To enter standby mode, set the enable pin to low (0V).
- The device will consume approximately 1.0 μA in this mode.
Active Mode:
- To activate the device, set the enable pin to high (Vcc).
- The device will consume up to 10 mA in active mode.
Input and Output Connections:
- Connect the input signal to the designated input pin.
- Ensure the input voltage is within the range of 0V to Vcc.
- The output signal will be available on the designated output pin.
- The output voltage will also be within the range of 0V to Vcc.
Temperature Considerations:
- Operate the device within the temperature range of -40°C to 85°C.
- Store the device within the temperature range of -55°C to 125°C.
Output Current:
- The device can provide a maximum continuous output current of 100 mA.
- For optimal performance, keep the output current below 50 mA.
Power Dissipation:
- Ensure that the power dissipation does not exceed 500 mW to avoid overheating.
Response Time:
- The device will respond to input changes within 10 μs.
Handling and Installation:
- Handle the device with care to avoid static damage.
- Follow proper soldering techniques to ensure reliable connections.
Testing:
- Test the device under typical operating conditions to verify its performance.
- Use a multimeter to check the supply voltage, input, and output signals.

(For reference only)