BT137B-600E: 马来西亚的首选 Utsource Holding Company Limited

详情

BUY BT137B-600E https://www.utsource.net/itm/p/12610374.html

Parameter	Symbol	Min	Typical	Max	Unit	Condition
Forward Voltage	V_F	-	1.2	1.5	V	I_T = 1 A, T_j = 25°C
Holding Current	I_H	5	-	15	mA	V_T = 10 V, T_j = 25°C
Latching Current	I_L	10	-	30	mA	V_T = 10 V, T_j = 25°C
Peak Forward Surge Current	I_FSM	-	-	100	A	t = 10 ms, T_j = 25°C
Maximum Repetitive Peak Forward Voltage	V_DRM	-	-	600	V	T_j = 25°C
Maximum Repetitive Peak Reverse Voltage	V_RRM	-	-	600	V	T_j = 25°C
Maximum RMS On-State Current	I_T(RMS)	-	-	16	A	T_j = 25°C, sinewave
Gate Trigger Current	I_GT	5	-	15	mA	V_GT = 4 V, I_T = 1 A, T_j = 25°C
Gate Trigger Voltage	V_GT	-	1.5	2.5	V	I_GT = 10 mA, I_T = 1 A, T_j = 25°C
Junction Temperature	T_j	-	-	125	°C	-
Storage Temperature	T_stg	-40	-	125	°C	-

Instructions for Use:

Handling Precautions:
- Handle the BT137B-600E with care to avoid damage.
- Avoid exposing the device to excessive mechanical stress or thermal shock.
Mounting:
- Ensure proper heat sinking if operating at high currents or in high ambient temperatures.
- Use recommended PCB layout guidelines to minimize parasitic inductance and capacitance.
Electrical Connections:
- Connect the gate (G) to the control circuit with a short, low-inductance wire.
- Ensure that the main terminals (MT1 and MT2) are connected correctly to avoid reverse polarity.
Thermal Management:
- Monitor the junction temperature (T_j) to ensure it does not exceed 125°C.
- Use appropriate cooling methods such as heatsinks or forced air cooling if necessary.
Gate Drive:
- Apply a gate trigger current (I_GT) within the specified range to ensure reliable turn-on.
- The gate trigger voltage (V_GT) should be within the specified limits to avoid overvoltage.
Overcurrent Protection:
- Implement overcurrent protection to prevent damage from excessive currents.
- Use fuses or current limiters in the circuit design.
Storage:
- Store the device in a dry, cool place away from direct sunlight and corrosive environments.
- Observe the storage temperature range (-40°C to 125°C).
Testing:
- Perform initial testing at room temperature and gradually increase the load to verify performance.
- Regularly inspect the device for signs of wear or damage during operation.
Compliance:
- Ensure that the device is used in compliance with all relevant safety and regulatory standards.

(For reference only)