The K 928560 / K 928561 005 Thrust Washer is a high-precision engine crankshaft thrust washer manufactured by AE, designed for CASE 580 F and 580 G backhoe loaders. This component is installed on the crankshaft to control axial (end) movement, ensuring correct crankshaft alignment and stable engine operation.
Located at the crankshaft thrust bearing position (PHOTO NO. 24 & 25 in the exploded engine diagram), the thrust washer absorbs forward and backward forces generated during clutch engagement and engine load changes. Proper thrust clearance is critical to prevent crankshaft damage, excessive wear, and engine failure.
Manufactured to OEM-equivalent tolerances, this thrust washer provides excellent wear resistance, accurate thickness control, and long service life under heavy-duty operating conditions.
Engineered for crankshaft axial clearance control
Precision thickness for correct end-float setting
High wear-resistant bearing material
Essential for engine durability and smooth operation
OEM-equivalent quality by AE
Installed at crankshaft thrust bearing position
Refer to PHOTO NO. 24 & 25 in engine exploded diagram
Recommended replacement during engine overhaul or crankshaft service
Always measure crankshaft end play after installation
CASE 580 F
CASE 580 G
Engine – Pistons, Crankshaft & Bearings
AE
发动机曲轴止推垫
图示位置：第 24、25 号
K 928560 / K 928561 005 曲轴止推垫片 是由 AE 生产的高精度发动机零件，适用于 CASE 580 F 与 580 G 挖掘装载机。该零件安装在曲轴止推轴承位置，用于控制曲轴前后轴向间隙，确保发动机运转稳定。
在发动机结构图中，该止推垫位于 图示第 24 与 25 号位置。其主要作用是吸收离合器动作及负载变化所产生的轴向推力，防止曲轴前后窜动，从而避免严重的发动机磨损或损坏。
产品按 OEM 等同标准 制造，厚度精准、耐磨性强，适用于高强度工程作业环境。
控制曲轴轴向间隙的重要零件
精准厚度，确保正确端隙
高耐磨轴承材料
提升发动机寿命与稳定性
AE 品牌，品质可靠
安装于 曲轴止推轴承位置
请参考 发动机图示第 24、25 号
建议发动机大修时一并更换
安装后需检测曲轴端隙
CASE 580 F
CASE 580 G
发动机 – 活塞、曲轴与轴承系统
AE
