DKSB Engineering (M) Sdn Bhd provides professional booster pump reconditioning to fix leakage, reduce vibration, and restore stable water pressure. We support service and repair for buildings, factories, and facilities across Kuala Lumpur and Selangor.
Booster pump reconditioning is a complete refresh of key pump parts that wear over time. Instead of “just running until it fails,” reconditioning helps your pump run smoother, maintain pressure, and reduce unexpected breakdowns.
To speed up quotation: share booster pump photos, nameplate details (kW/HP), and your site location in KL/Selangor.
Most booster pump issues start small and get worse over time. Early servicing can prevent water supply disruption and costly damage.
Worn seals can leak and allow water to enter areas that should stay dry.
Misalignment, looseness, or imbalance can cause vibration and shorten pump life.
Worn bearings can create noise, heat, and unstable operation.
Debris or internal wear can reduce flow and cause pressure drop.
Common warning signs: pressure fluctuates, pump cycles too often, unusual noise, visible leakage, hot casing, or frequent motor trips.
We follow a clear, documented workflow so your booster pump can restart safely and run reliably. You will receive a simple report that helps maintenance teams plan next steps.
Confirm symptoms and check base condition, coupling, and visible leakage.
Open the pump safely and inspect internal parts for wear and damage.
Replace parts that commonly fail (seal, bearing, gasket/O-ring) based on condition.
Reassemble, check alignment, run test, and confirm pressure stability.
Service goal: stable pressure, reduced vibration, and fewer unplanned shutdowns.
Downtime depends on pump condition, access, and parts availability. We prioritize safe work practices and a stable restart.
| Scope Item | Purpose | Notes |
|---|---|---|
| Mechanical seal replacement | Stop leakage at the shaft area | Correct selection helps prevent repeat leaks |
| Bearing replacement | Reduce noise and stabilize rotation | Proper fitting and lubrication are important |
| Impeller/casing inspection | Restore flow and reduce pressure drop | Wear or blockage can cause weak pressure |
| Alignment & test run | Reduce vibration and ensure stable restart | Recommended after any major disassembly |
For critical water systems, ask about planned shutdown servicing to reduce downtime risk.
Malaysia
