Renishaw SCR200 Stylus Change Rack
Stylus module rack for use with TP200
- Rapid automatic changing of stylus modules without the need to requalify stylus tips
- Powered by PI 200-3
- Incorporates features to facilitate safe stylus changing
- Leg mounted or rail mounted versions available
.Dimensions
SCR200
SCR200-R
NOTE: Dimensions in mm (in).
Specification
|
Weight |
0.75 kg |
|
Mounting orientation |
Vertical or horizontal |
|
Mounting fixture |
Single stud (M8, M10) |
|
Number of ports |
6 |
|
Repeatability of stylus change (2σ) at 50 mm |
Automatic ≤1 μm Manual ≤2 μm |
|
Entry speed |
Unrestricted |
|
Module pull-off force |
800 g maximum |
|
Overtravel protection |
Electromechanical (5 minimum deflection) |
|
LED indicators |
|
|
Power |
Green |
|
Status |
Red (flashing during probe inhibit) |
|
Change cycle detection |
Optoelectronic beam system with Hall effect proximity sensor |
|
Multi-rack usage |
Up to two SCR200 units (12 ports) may be connected with a special cable |
Installation
All alignment requirements and port docking co-ordinates can be established with only eight probing points. No control signals from the CMM are required.
|
Alignment adjustment |
XY rotational only ±0.1 mm |
|
Docking tolerance |
X 0.17, Y 1.5 mm, Z 2 mm |
|
Power supply / control |
PI 200-3 interface |
|
Cable length |
20 m maximum (PI 200-3 to SCR2000) |
|
Cable connection |
6-pin miniature DIN socket |
|
Set-up time |
<30 minutes |
