DKSB Engineering (M) Sdn Bhd supplies and supports a Complete Set Of Mission Pump for dependable fluid transfer and stable operation. We help customers with selection, installation guidance, inspection, and servicing across Kuala Lumpur and Selangor.
A complete set means you get the main pump and the essential parts that help it run smoothly as a system. This reduces mismatching issues and helps your team start up safely with fewer delays.
If you have an existing setup, we can match the pump to your piping and operating needs to avoid repeated trips, leaks, or unstable flow.
Many pump problems are not “bad pumps” — they are caused by mismatch, poor installation, or worn parts around the pump. A complete set helps reduce these common risks.
When pump size or speed doesn’t match the job, it can lead to overheating, noise, and frequent shutdown.
Misalignment puts extra stress on bearings and seals, causing vibration and early wear.
Worn or incorrectly installed seals can lead to leakage, mess, and damage to nearby equipment.
Incorrect grease/oil level or contamination reduces bearing life and increases running temperature.
Common warning signs: unusual sound, high vibration, frequent tripping, seal leakage, hot bearing area, or unstable flow.
We keep it simple and practical. The goal is to deliver a pump set that runs stable, with clear guidance your team can follow.
Confirm flow requirement, operating hours, fluid condition, and site constraints.
Recommend a suitable pump set and key parts to reduce mismatch and repeat failures.
Assist on alignment basics, mounting, and checks that help prevent vibration and leakage.
Run checks for leakage, noise, and stable operation, then provide a simple handover summary.
This service is designed for maintenance teams who want clear steps, not complicated explanations.
Downtime depends on site access, piping condition, and whether old parts are stuck or damaged. We focus on safe work and a stable restart.
| Scope Item | Why it matters | Notes |
|---|---|---|
| Complete pump set review | Helps prevent mismatch and repeated issues | We check suitability based on your operating needs |
| Alignment and mounting checks | Reduces vibration and early bearing wear | Recommended after any pump change or base work |
| Seal and leakage checks | Prevents water/fluid loss and damage | Early correction reduces downtime later |
| Start-up stability check | Ensures smoother operation and fewer trips | Includes basic observations during initial running |
For critical sites, we recommend planning the work during scheduled shutdown windows.
Malaysia
