DKSB Engineering (M) Sdn Bhd provides professional boiler feed pump recondition to reduce leakage, improve pressure stability, and restore smooth running. We support fast turnaround for facilities across Kuala Lumpur and Selangor.
Boiler feed pump reconditioning is a complete service to bring a worn pump back to reliable operation. We check key wear parts, replace what is needed, and verify performance before handover—so your boiler system can run with fewer interruptions.
To speed up quotation: share pump model, capacity/pressure (if available), motor kW/HP, and photos of nameplate + leak area.
Boiler feed pumps work under demanding conditions. Small issues can grow into unplanned shutdowns if not addressed early.
Heat and continuous running can wear seals and cause leakage at the shaft area.
Worn bearings can create vibration, noise, and overheating that damages internal parts.
Impeller and wear parts can erode over time, reducing pressure and flow.
Poor alignment, pipe strain, or unstable supply can shorten pump life.
Common warning signs: leakage near the pump, pressure fluctuations, unusual noise, higher motor load, frequent trips, or hot bearing housing.
We follow a clear, step-by-step workflow to reduce risk and return the pump to stable operation. You receive practical notes that help prevent repeat problems.
Confirm the problem (leak, pressure drop, noise) and check external condition.
Open the pump safely and assess internal wear parts, shaft, and seal area.
Replace bearings and seals, repair/replace worn parts, and ensure proper fitment.
Reassemble, verify leakage condition, and check for stable running behavior.
Important: If the pump keeps failing, the cause may be outside the pump (pipe strain, alignment, water quality, or operating conditions). We highlight these risks clearly in the report.
Downtime depends on access, pump condition, and spare part availability. We focus on safe work practices and a stable restart.
| Scope Item | Purpose | Notes |
|---|---|---|
| Bearing replacement | Reduce vibration and protect internal parts | Correct fit and lubrication are important |
| Seal replacement | Stop leakage and prevent bearing damage | Correct seal selection is critical |
| Impeller / wear part inspection | Restore pressure and performance | Worn parts can reduce output significantly |
| Reassembly & checks | Confirm stable operation | Helps reduce repeat failures after restart |
For critical boiler operations, ask about planned shutdown support and standby strategy to reduce downtime risk.
Malaysia
