SA575DTBR2G
SA575DTBR2G

 

SA575DTBR2G

Utsource Holding Company Limited flag
Category: Available (Qty:9999999)
For more information, visit our official website at utsource.us
Visit Official Site Contact Us
Description

BUY SA575DTBR2G https://www.utsource.net/itm/p/546614.html
Low Voltage, Precision Dual Gain Control Compandor; Package: TSSOP 20 LEAD; No of Pins: 20; Container: Tape and Reel; Qty per Container: 2500

Parameter Description Value
Part Number Full part number SA575DTBR2G
Type Type of device Power Diode
Package Package type TO-220AB
Polarity Polarity of the diode Rectifier
Maximum Reverse Voltage (VRSM) Maximum reverse voltage the diode can withstand without breakdown 600 V
Maximum Forward Current (IF(AV)) Maximum continuous forward current at 25°C ambient temperature 5 A
Peak Forward Surge Current (IFSM) Maximum peak forward surge current (10 ms single half sine-wave) 100 A
Forward Voltage Drop (VF) Typical forward voltage drop at specified forward current (IF = 5 A) 1.1 V
Reverse Recovery Time (trr) Time taken for the diode to recover from forward to reverse conduction 35 ns
Operating Temperature Range (TOP) Range of operating temperatures -55°C to +150°C
Storage Temperature Range (TSTG) Range of storage temperatures -65°C to +150°C
Thermal Resistance (RθJC) Thermal resistance from junction to case 2°C/W
Mounting Torque Recommended mounting torque for screws 10 Nm

Instructions for Use:

  1. Handling and Storage:

    • Store the diode in a dry, cool place away from direct sunlight.
    • Handle with care to avoid mechanical damage.

  2. Mounting:

    • Ensure the mounting surface is clean and flat.
    • Apply thermal compound between the diode and heat sink for better thermal performance.
    • Tighten the mounting screws to the recommended torque (10 Nm).

  3. Electrical Connections:

    • Connect the diode according to the polarity markings on the package.
    • Ensure all connections are secure and free from corrosion.

  4. Operational Considerations:

    • Do not exceed the maximum reverse voltage or forward current ratings.
    • Ensure adequate cooling to keep the junction temperature within the specified range.
    • For applications involving high surge currents, verify that the peak forward surge current rating is not exceeded.

  5. Testing:

    • Use a multimeter to check for continuity and proper operation.
    • Perform a reverse bias test to ensure the diode does not conduct under reverse voltage conditions.

  6. Disposal:

    • Follow local regulations for the disposal of electronic components.
    • Recycle where possible to minimize environmental impact.
(For reference only)

More detail about Utsource Holding Company Limited
Utsource Holding Company Limited
Utsource Holding Company Limited Electronic Component Wholesaler, IC Chip Distributor, IGBT Module Supplier in California, USA | Utsource Holding Company Limited
Contact Us flag