Elec-component
BT137B-600E
BT137B-600E

 

BT137B-600E

Utsource Holding Company Limited flag
Category: Elec-component Available (Qty:9999999)
For more information, visit our official website at utsource.us
Visit Official Site Contact Us
Description

BUY BT137B-600E https://www.utsource.net/itm/p/12610374.html

Parameter Symbol Min Typical Max Unit Condition
Forward Voltage VF - 1.2 1.5 V IT = 1 A, Tj = 25°C
Holding Current IH 5 - 15 mA VT = 10 V, Tj = 25°C
Latching Current IL 10 - 30 mA VT = 10 V, Tj = 25°C
Peak Forward Surge Current IFSM - - 100 A t = 10 ms, Tj = 25°C
Maximum Repetitive Peak Forward Voltage VDRM - - 600 V Tj = 25°C
Maximum Repetitive Peak Reverse Voltage VRRM - - 600 V Tj = 25°C
Maximum RMS On-State Current IT(RMS) - - 16 A Tj = 25°C, sinewave
Gate Trigger Current IGT 5 - 15 mA VGT = 4 V, IT = 1 A, Tj = 25°C
Gate Trigger Voltage VGT - 1.5 2.5 V IGT = 10 mA, IT = 1 A, Tj = 25°C
Junction Temperature Tj - - 125 °C -
Storage Temperature Tstg -40 - 125 °C -

Instructions for Use:

  1. Handling Precautions:

    • Handle the BT137B-600E with care to avoid damage.
    • Avoid exposing the device to excessive mechanical stress or thermal shock.

  2. Mounting:

    • Ensure proper heat sinking if operating at high currents or in high ambient temperatures.
    • Use recommended PCB layout guidelines to minimize parasitic inductance and capacitance.

  3. Electrical Connections:

    • Connect the gate (G) to the control circuit with a short, low-inductance wire.
    • Ensure that the main terminals (MT1 and MT2) are connected correctly to avoid reverse polarity.

  4. Thermal Management:

    • Monitor the junction temperature (Tj) to ensure it does not exceed 125°C.
    • Use appropriate cooling methods such as heatsinks or forced air cooling if necessary.

  5. Gate Drive:

    • Apply a gate trigger current (IGT) within the specified range to ensure reliable turn-on.
    • The gate trigger voltage (VGT) should be within the specified limits to avoid overvoltage.

  6. Overcurrent Protection:

    • Implement overcurrent protection to prevent damage from excessive currents.
    • Use fuses or current limiters in the circuit design.

  7. Storage:

    • Store the device in a dry, cool place away from direct sunlight and corrosive environments.
    • Observe the storage temperature range (-40°C to 125°C).

  8. Testing:

    • Perform initial testing at room temperature and gradually increase the load to verify performance.
    • Regularly inspect the device for signs of wear or damage during operation.

  9. Compliance:

    • Ensure that the device is used in compliance with all relevant safety and regulatory standards.
(For reference only)

More detail about Utsource Holding Company Limited
Utsource Holding Company Limited
Utsource Holding Company Limited Electronic Component Wholesaler, IC Chip Distributor, IGBT Module Supplier in California, USA | Utsource Holding Company Limited
Contact Us flag